Build guide

ReikiCannon

Line a brooder lamp’s aluminum dish with terahertz, tourmaline, jade, and quartz. Shop sequence only. Experimental hardware — not a medical device.

Sequence

– / 8

Plate 03

Sequence

01Open a ventilated benchUnplug the lamp and pull the bulb. Mix and heat the epoxy in moving air — he calls it a ventilated arena. Gloves on. Nothing flammable under the dish.02Sand the inside of the dishDull the whole inner face of the aluminum, then wipe the dust out. This is the step he names first. Smooth metal sheds stones.03Sort the stones before any epoxy is openKeep the kilo of terahertz as the body of the liner. Set the 75 g piles of jade, tourmaline, and quartz aside so they get scattered, not dumped in the first quarter you touch.04Mix a thick quarter-batch of JB WeldFollow the package ratio. Thick, not runny. Only as much as one quarter of the dish — a full dish’s worth skins over before you can set the stones.05Bed that quarter, stones off the metalButter the sanded quarter. Press stones into the wet layer so epoxy stays between stone and aluminum. He is explicit about a thick bed and about keeping the stones from contacting the metal.06Heat-gun that quarter for ten minutesKeep the gun moving. You are kicking the cure, not cooking the cord, the clamp, or a bare patch of epoxy. If it scorches or smokes hard, back off.07Walk the other three quartersSame sequence: mix, butter, stones, ten minutes of heat. Overlap the edges so you don’t leave a bald stripe of aluminum. Distribute the minority stones as you go.08Wait until it is actually hardThe heat gun is a head start, not a substitute for a finished cure. If a stone still shifts under a thumbnail, leave it. The bulb does not go back in while the bed is soft.

Plate 04

First fire

Epoxy hard. Stones don’t shift. Bulb seated in a fixture rated for that wattage.
Non-flammable surface. Cord and clamp outside the cone. Nothing cloth near the dish.
Stay with it. The full lamp throws real heat. Kill power if the socket or cord smells or discolors.
Short sessions first. He tells people to go slow, and he has watched someone have to stop.

Plate 05

Shop rules

Ventilate while you mix JB Weld and while the heat gun is on it. Don’t breathe the warm mix.
250 W infrared will burn skin and light nearby fabric. Never leave it running alone.
Don’t stare into the bulb. Dry hands. No water on the bench.
If anyone feels dizzy or off, switch it off. That is a stop rule, not a benefit.

ReikiCannon

Bill

Mix

Sequence

First fire

Shop rules